Safety
Warning!!
Not all the safety tests are enabled, please take extra care before charging your vehicle.| Test | Status |
|---|---|
| GFI Self Test: | |
| Ground Monitoring: | |
| Stuck Contact Detection: | |
| Temperature Monitoring: | |
| Diode Check: | |
| Vent Required: | |
| Error | Count |
| GFCI: | |
| No Ground: | |
| Stuck Contact: |
OhmConnect 
OhmConnect monitors real-time conditions on the electricity grid. When dirty and unsustainable power plants turn on, our users receive a notification to save energy.
Ohm Hour:
Ohm key:
USA - California only
Ohm Key can be obtained by logging in to OhmConnect, enter Settings and locate the link in "Open Source Projects"
Example: https://login.ohmconnect.com/verify-ohm-hour/OpnEoVse
Key: OpnEoVse
EVSE Error
| Current | Energy | Temp | Elapsed |
|---|---|---|---|
Charge Options
Time limit:
Energy limit:
Start: Stop:
Energy Use
| This Session: | |
| Total: |
Sensor Readings
| Max Current: | |
| Charging Current: | |
| Temp: | |
| Volts: |
Advanced
| Expert Mode: | |
| Developer Mode: |
Setup
Time: No RTC detected
Time:
Service Level:
Max Current:
About GoPlug
| Serial Number: | |
| E-Firmware: | |
| W-Firmware: |
Energy Monitoring
Emoncms Server*:
e.g: emoncms.org, emonpi/emoncms
Emoncms Node*:
Emoncms write-apikey*:
Emoncms SSL SHA-1 Fingerprint (optional):
HTTPS will be enabled if present e.g: 7D:82:15:BE:D7:BC:72:58:87:7D:8E:40:D4:80:BA:1A:9F:8B:8D:DA
Connected: Successful posts:
Firmware Update
MQTT
{base-topic}/data
Host*:
e.g 'emonpi', 'test.mosquitto.org', '192.168.1.4'
Username: blank - no authentication
Password: blank - no authentication
Base-topic*:
e.g 'goplug_9068'
Solar PV divert
1. Normal (default):
- Charge at maximum current set by EVSE.
- If only solar PV feed available: charge rate is modulated based on solar PV generation.
- If grid +I/-E (positive Import / negative Export) feed is available: charge rate will be modulated by available excess power.
- If EVSE is sleeping: charging will begin when solar PV / excess power > min charge rate.
- Charging will not pause; this avoids excess wear on the EVSE relay and the EV.
SolarPV-gen topic:
Solar PV MQTT topic to modulate charge rate based on solar
Grid (+I/-E) topic:
Grid (+I/-E) MQTT topic to modulate charge rate based on excess power
Charge Mode
MQTT config not configured with Solar PV / Grid topic.
Solar PV Divert requires the SolarPV-gen or Grid (+I/-E) MQTT topic to be defined on the Services tab.1. Normal (default):
- Charge at maximum current set by EVSE.
- If only solar PV feed available: charge rate is modulated based on solar PV generation.
- If grid +I/-E (positive Import / negative Export) feed is available: charge rate will be modulated by available excess power.
- If EVSE is sleeping: charging will begin when solar PV / excess power > min charge rate.
- Charging will not pause; this avoids excess wear on the EVSE relay and the EV.
Charging mode can also be set via MQTT:
{base-topic}/divertmode/set
Solar: Grid Import/Export: W - | Charge rate: A